berpassion.blogg.se - Como instalar los drivers vcds lite 1.2 release

#Como instalar los drivers vcds lite 1.2 release install
#Como instalar los drivers vcds lite 1.2 release serial
#Como instalar los drivers vcds lite 1.2 release update
#Como instalar los drivers vcds lite 1.2 release driver

#Como instalar los drivers vcds lite 1.2 release install

Install and run the software while logged in as an Administrator if needed. Make sure you have write permission where VCDS is installed (reinstall in the Documents folder if necessary), and remove any extension cable between the PC and the interface. There are may be several entries with "Root Hub" so make sure to uncheck this on each of them like this:

#Como instalar los drivers vcds lite 1.2 release serial

Specifically, check to make sure that Windows is not turning off the USB ports: go to Device Manager, Universal Serial Bus Controllers, USB Root Hub, Properties, Power Management, and uncheck "Allow Windows to turn off this device to save power". If you encounter difficulties, check FAQ 2.4 and 2.5 When it's done click Close then Saveħ) At this point all of the buttons in VCDS should be available so you should try communicating with the car, for example by clicking on Select then 01-Engine then Fault Codes-02.

#Como instalar los drivers vcds lite 1.2 release update

Legacy dongle HEX-, Micro-, KII-, KEY- interfaces do not need Internet access to update but DO need to remain connected to both the car and USB.

Use the Config button to update firmware as explained in this HEX-NET video or this HEX-V2 video.

HEX-NET or HEX-V2 interfaces need Internet access to update but do not need to remain connected to the car, just plugged in via USB.

If you test without a car it will be unable to check for a firmware update and will be unable to update.Ħ) If the Options>Test result shows everything OK but Firmware Update Required, click OK then Update. It doesn't matter if it's a VW/Audi, just something with an OBD-2 port with the key ON. In order to fully test the interface, it needs to be connected to a car so that the interface has 12V of power. You should acknowledge that message then go to Options and click Test. If needed, exit out of VCDS then repeat steps 1-3.ĥ) You should get a message saying something about "First Use, No Config File". Check the shortcut on your desktop to make sure it's for Release 21.9. If says an older version then something didn't go right. Make sure it says Release 21.9 at the top of the screen.

If VCDS won't start up at all after updating, make sure that Zone Alarm or your virus scanner are not blocking/quarantining the file. If you encounter difficulties, try these instructions:Ĥ) Start up VCDS (it may have already started at the end of the installation, which is fine).

#Como instalar los drivers vcds lite 1.2 release driver

Depending on the version of Windows it may pop up with a USB Driver Installation Wizard or it may just automatically do its thing. At the end of the installer, it will prompt you to install USB drivers which you should let it do as well.ģ) If your interface is plugged into a USB port, unplug it, leave it unplugged for 5 seconds then plug it back in. The updater in VCDS should accomplish the same thing but when in doubt, install a fresh copy.Ģ) Allow the installer to run through completely, agree to the terms, and unless you have some compelling reason to the contrary, allow it to install into its default location with the default installation options. Therefore, here are some things to try if "it doesn't work".ġ) Make sure you have downloaded Release 21.9 from our website and installed it onto your PC: The natural human inclination seems to be to blame the last thing that has changed but we have found explanations and resolutions for most of these cases. In the past, we have gotten some reports from customers of "stuff not working" after updating VCDS.